(RADIATOR) AuthBy DYNADDRESS & Cisco 5300

[Ronan Eckelberry]

	I am using Radiator with an AS5300.  It may help if I could see
your configs (no secrets) and a Trace 4 debug from Radiator.

-Ronan


-----Original Message-----
From: owner-radiator at open.com.au [mailto:owner-radiator at open.com.au] On
Behalf Of Anthony D Cennami
Sent: Thursday, 18 April, 2002 10:58
To: radiator at open.com.au
Subject: (RADIATOR) AuthBy DYNADDRESS & Cisco 5300



I seem to be having a problem with a Cisco 5300 / Radiator config.

If I hardcode an IP address into the users file (<AuthBy FILE>) all 
seems to work well.  However, if I leave no IP address and attempt to 
use the <AuthBy DYNADDRESS> following the AuthBy FILE, debug reports a 
successful authentication and shows that an IP address was successfully 
assigned, but the Cisco/Windows DialUp claims authentication failed and 
closes the connection.

Is there a simple/known configuration on Radiator/Cisco that I am simply

overlooking?

Any insight is appreciated.

Thanks,

Anthony


===
Archive at http://www.open.com.au/archives/radiator/
Announcements on radiator-announce at open.com.au
To unsubscribe, email 'majordomo at open.com.au' with
'unsubscribe radiator' in the body of the message.

===
Archive at http://www.open.com.au/archives/radiator/
Announcements on radiator-announce at open.com.au
To unsubscribe, email 'majordomo at open.com.au' with
'unsubscribe radiator' in the body of the message.