(RADIATOR) Config problem.

[Hugh Irvine]

Hello Quintin -

You are correct, the file is only read when Radiator starts up.

regards

Hugh


On Tuesday 18 September 2001 13:32, Quintin Lam wrote:
> Dear Hugh,
>
> My configuration as below
>
> <AuthBy LDAP>
>     Identifier accessbb
>     Host xxx.xxx.xxx.xxx
>     Port 389
>     AuthDN      xxxx
>     AuthPassword        xxxx
>     BaseDN      ou=xxxx,o=xxxx,o=CTM
>     Scope       base
>     UsernameAttr        uid
>     PasswordAttr        userpassword
>     AuthAttrDef accessbb,NAS-Address-Port-List,check
>     SearchFilter (&(accessbb=accessbb)(uid=%1))
> </AuthBy>
>
> We have an file named accessbb which is used for "AuthAttrDef" above. We
> notice that everytime the file is changed, we must kill the radiusd daemon
> and start again. The accessbb file cannot be read after sending a signal
> "HUP" to radiusd.
>
> Thanks!
>
> Quintin
>
>
> ===
> Archive at http://www.open.com.au/archives/radiator/
> Announcements on radiator-announce at open.com.au
> To unsubscribe, email 'majordomo at open.com.au' with
> 'unsubscribe radiator' in the body of the message.
>
>
> 
===
Archive at http://www.open.com.au/archives/radiator/
Announcements on radiator-announce at open.com.au
To unsubscribe, email 'majordomo at open.com.au' with
'unsubscribe radiator' in the body of the message.