[RADIATOR] Installation on OpenWRT

[Alexander Hartmaier]

Hi,

Radiator is written in Perl, so check line 14 of Makefile.PL and figure
out what's going wrong.
Maybe some of your Perl modules are too old.
32MB of memory are really not much!
Radiator takes 28MB on our prod server which isn't really a lot for a
Perl app.

--
Best regards, Alex


Am Donnerstag, den 19.08.2010, 17:16 +0200 schrieb Andrea Coppini (AIR
Networks):
> Hi,
>
> I'm trying to install Radiator on an OpenWRT OS (www.openwrt.org).  I have
> 256Mb of disk and 32Mb of RAM allocated to OpenWRT, which should be plenty.
>
> I have installed all the Perl and Perlbase modules successfully, and
> unzipped Radiator-Locked-4.7 to the root.  I'm logged in as root, no
> password (this is a test system).
>
> When I run 'perl Makefile.PL', I get the following error:
> ----
> ExtUtils/Install.pm did not return a true value at Makefile.PL line 14.
> BEGIN failed--compilation aborted at Makefile.PL line 14.
> ----
> Any ideas what this might be? And how I could fix it?
>
>
> Regards
> Andrea
>
>
> _______________________________________________
> radiator mailing list
> radiator at open.com.au
> http://www.open.com.au/mailman/listinfo/radiator


*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*
T-Systems Austria GesmbH   Rennweg 97-99, 1030 Wien
Handelsgericht Wien, FN 79340b
*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*
Notice: This e-mail contains information that is confidential and may be privileged.
If you are not the intended recipient, please notify the sender and then
delete this e-mail immediately.
*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*"*